3D Advertising Pylon with Smart Trash & Recycle Bin

I am prototyping a display for a startup that will be mounted on the tops of vehicles. It will eventually be either CNC milled or 3D printed, depending on the material decided on. For this display I am looking for a sleek case design that also meets the specifications below. The display panel itself is 81.75625 cm x 15.24 cm and needs to be able to slide into and out of the case when a side panel is removed. The electronics are mounted on the back of the display panel and require a clearance of 5.08 cm. There needs to be a source of ventilation for the electronics except on the top as it will be outdoors, as well as one usb port and space for the power cable on the bottom of the display case. For the feet, they will be made of magnets with quite a strong pull force that have been dipped in rubber to prevent scratching. This also needs to be accounted for in the design with there being 3 to 4 feet supporting the case. There are other cases for various products that need to be designed/redesigned, so we would like to find somebody to work with through this contest.

This is about a first product draft, which shall later be turned into a production ready design. I need an enclosure for a custom made electronic part. The rough form-factor should be similar to a navigation system (see attached files) with a display in front and parallel enclosure boundaries, slightly rounded edges. The display is 4.3 inches wide (see technical details attached) and should be included in the rendering. The enclosure should be 4 cm deep. As a bonus, the display shows attached bar diagram. At the back, there should be the possibility for a DIN rail mount, top hat rail EN 50022 – 35 × 7.5 but also for direct wall mount using screws or mounting to a bar with cable ties. At the front left side of the enclosure, I need a C14 inlet to add a power cable and a Schuko socket: https://en.wikipedia.org/wiki/Schuko or CEE 7/3 socket. See attached figure of the design. The material should be dark grey with a bit reflective surface. Please add our logo to the upper left corner of the front, below the display. If it fits optically, it could glow a bit in green.

I am impressed with results of the previous kick scooter challenge and invite all to a similar contest. Want: • A convenient and appealing form of local transportation for adults • Artistic renderings of concept and drawings of your final rendering • May communicate more wants during contest to aid overall direction and to keep opportunity available to all Contest is for 3-wheeled scooter designs (2-front, 1 rear - steering can be with either front wheels or rear wheel) Main Competitors: https://www.cycleboard.com/ http://muv-e.com/ http://www.mercanewheels.com/project-1

We are Resinbees, a smoking accessories company based in Montreal ,Quebec Canada.We are looking to design a new nail. The nail is to be placed at the****of a glass pipe and the tip heated with a butane torch till its red hot.We will send the design to be manufacture (Milling Machine) so please be as detailed as possible.Feel free to ask some questions if you need more information.

Looking for help with a redesign for skateboard wheel stoppers. These skateboard wheel stoppers prevent the wheels on the skateboard from rolling when practicing tricks. These are rubber pieces that can be slipped on skateboard wheels to stop them from rolling while learning ollies, kickflips and other skateboarding tricks. More information about it can be found here: http://www.skatertrainer.com