CAD Design of Lighter Prototype - 3D Vector Format

I have Various Shapes That I seek to Have Produced ,for Enthusiast, my First Project will be my Favorite Subject. CATS. I'm a cat mom and would like to eventually have this Produced.The Best Cat BONG Design.

We have recently purchased an older site furnishing manufacturer and would like to introduce a new and more modern product line. http://street.woodcraftdesignltd.com/ Please feel free to visit the current website to see our existing products. We primarily want a Park Bench Waste and recycling receptacle A lighted bollard Later on adding a Poster Pillar and a Bike rack Our chosen new line will be put into production and therefore will need to be Modern,lightweight but durable,as maintenance free as possible and not too complicated to manufacture and assemble. In our existing product we use the following materials Steel and Aluminum for structure Cedar, Ipe and Oak for seating Our most popular bench size is 1800mm We would like to incorporate composite materials for a seating option (bearing in mind we have had issues with composite sagging in heat We would like to compete with companies such as Maglin and Wishbone Our existing products do not have any CAD drawings included and this makes it more difficult for us to be specified in by landscape architects. We are not sure exactly what they require and any guidance in that would be appreciated.

Looking for a unique computer mouse concept that can enclose a finger wearable ring inside and has a clear opening cover. The cover acts like a see-through area for the ring and can be easily opened for the retrieval of the ring. The optimal solution would have minimum parts and design of manufacturing feasibility. The cover hinge should be sturdy to support a long lifespan. - The mouse design should have ergonomic curve geometry to rest the thumb of the users. - A compact design that can house two AAA batteries and the PCB board is required. - The bottom part should have an opening to expose the optical sensor of the mouse. - No power slide switch is needed since it is provided on the ring. When the cover is open, no electronic board should be visible Approximate dimensions – L 115mm x W 66m (as compact as possible) - LED requirement - An LED indicator needs to be provided on the mouse (see the image attached with dimensions) - Battery – Should have an opening for a battery for the replacement. - Required file format -. step *Note – The base of Finger wearable ring to be in level with the base of mouse (see the image attached)

We are a start-up design company based in Mullingar and supported by Enterprise Ireland as a HPSU. We require an experienced solidworks engineer to complete various sheet metal components in flat sheet and folded. Initially we would require in the region of 20/30 hours service which may be extended.

New kettlebell design. I would like 3d CAD drawings with details measurements to use for producing moulds for a new kettlebell range in cast iron. from range of 5KG to 24KG.(5,8,12,16,20,24kg). Front and rear with a flat surface, one side showing weight in both KG/LBS, the otherside left blank for logo. Handlewidth diameter (35mm) and dimensions between horns of handle and handle to ball distance for all kettlebells shoud be the same. At the base of the kettlebell, a circular handle built into the design should be larger than the kettlebell base, with 28mm grip diameter, and the first few cm of the base hollowed out to allow a hand and fingers to reach inside and grip almost all the way around the bar throughout the full circle.