Interchangeable Battery Adapter Holster Pack - Industrial CAD Designer
-
Open
-
Choosing Finalist
-
Ended
I need someone to help me make a interchangeable battery clip adapter where these Ryobi batteries (found from Home depot) clip into each other as seen in picture
It must be able to maintain enough room and functionality where the electrical terminals make proper contact.
The batteries in the picture are laid out exactly how I want it to clip into each other. Just fill in the space between the battery with the housing that I need for you to design. I also need an access port about 7mm in diameter.
The designer must already have access to these batteries which are common from home depot.
-how well the battery clips into the adapter
-the placement of a access port about 7mm in diameter
-the ability for me to wire up the terminals inside before final assembly
-the ability for me to install the electrical contact terminals
- commonly used application that I can take to 3D print (shapeways.com) and even full production molding.
Entries
Discussion
Showing last 20 comments - View AllDesigner
Designer
Designer
Designer
Designer
Buyer
Hi,
Your picture is exactly what I want, but I would have no clue as to how to provide you the dimensions. That&;s why i mention the battery from home depot as they are sold in every store and I was hoping anyone who has their tools would have it in their garage.
Designer
Buyer
Did you get the final dimensions? Is the cad drawing accurate and I can take it to the 3D print and use right away?
Thanks,
Mike
Designer
Buyer
I will check exactly dimensions of the common batteries from Home Depot, after that I will recommend you about the
interchangeable battery clip adapter. What kind of batteries do you usually use? ( brand, dimension?
Kind regards,
3D Technical Service Group
http://vdms.wordpress.com/
Designer
Buyer
Designer
Buyer
Buyer
Designer
Buyer
Buyer
Sergiu.Nasta
Designer